|
First of all, please make sure that there is AT45DB081*/ AT45DB161*/AT45DB321* chipset
in your modem/router.The flash program is used for them ONLY.
There is a 6-pin interface in modem/router used for connected to the
LPT of computer.
the connection of 6-pin interface to chipset
1---AT45DB161* 13
2---AT45DB161* 14
3---NOT connected to AT45DB161* (But connected to 4th-pin of LPT
with invariable 3.3v voltage)
4---AT45DB161* 11
5---AT45DB161* 12
6---AT45DB161* 7
The connection of LPT to the 6-pin interface(make a connection
cable following method)
LPT 6-pin
interface
4 -------- 3
5 -------- 1
6 -------- 5
7 -------- 4
11 -------- 2(WITH 100¦¸
Resistance 0.25w)
18 -------- 6
Make a cable in above method.
PUT the teimage.bin into the same directory of loadfi.exe.(Suggest
put them into a partition that the real-mode DOS can
recognise,FAT16/FAT32 etc.)
Reboot to real-mode DOS(NEEDED WIN98 bootdisk).
DON'T Power up the modem/router , USE the cable Connect LPT to the
6-pin interface.
Power up the modem/router, run the loadfi.exe, press "1"
to write the teimage.bin into flashrom.
P.S : IF the loadfi print a message "Cable1: No
Connection",
For this:
1. You maybe have to reverse the 6-pin order of cable.
2. Maybe there is a 2-pin
interface have to be short.
3. Check the cable was correctly made. 
|